Philosofy
503 posts
Jan 04, 2014
3:38 PM
|
My question is specific, but thought this would be a good thread to collect this information.
What size screws does Suziki use for their reed plates?
Thanks
Phil
|
nacoran
7470 posts
Jan 04, 2014
3:54 PM
|
I don't know for Suzukis, but here was Arzajac's advice on my MB/Pre-MS Bluesharps for tapping.
" If you use an M2 tap, you can drill through-and-through with 1/16 inch bit and tap that hole. On the opposite plate, make that hole bigger using any bit that's in between 3/32 to 1/8 inch (inclusive). If you are slightly off-center, the 3/32 inch hole may not give you enough clearance."- Arzajac
And he's got the screws listed on the For Sale thread-
http://www.modernbluesharmonica.com/board/board_topic/5560960/5459894.htm
----------
Nate
Facebook
Thread Organizer (A list of all sorts of useful threads)
|
arzajac
1244 posts
Jan 04, 2014
4:06 PM
|
M2 10 millimeter
----------
Custom overblow harps. Harmonica service and repair.
|
Philosofy
504 posts
Jan 05, 2014
11:10 AM
|
Thanks for the quick reply. My local Ace doesn't have them: where do you guys order online?
|
nacoran
7472 posts
Jan 05, 2014
12:45 PM
|
From Arzajac! Lol.
----------
Nate
Facebook
Thread Organizer (A list of all sorts of useful threads)
|
Philosofy
505 posts
Jan 05, 2014
6:51 PM
|
I'll take 40 Andrew!
|
