HarpNinja
2036 posts
Dec 21, 2011
6:45 PM
|
The screws in GM's and MBD's are M1.4, right? I think they are 3.9 or 4.mm. At any rate, where is a good place to order them in bulk?
I asked Hohner to send me some, but they sent me the coverplate screws for Crossovers by mistake - which is fine, but I need some more M1.4 screws.
Thanks!
----------
Mike
VHT Special 6 Mods
Quicksilver Custom Harmonicas - When it needs to come from the soul...
|
arzajac
708 posts
Dec 22, 2011
3:10 AM
|
I just double-checked to be sure and they are M1.6, not 1.4.
I get them from Microfasteners.com, but M1.6 are much easier to find than 1.4... so you probably can get them anywhere. 1 cm long...
----------
Last Edited by on Dec 22, 2011 5:26 AM
|
jim
1097 posts
Dec 22, 2011
3:48 AM
|
Seydel brass screws are identical. Sold at their website.
----------
Free Harp Learning Center
|
shbamac
179 posts
Dec 22, 2011
8:41 AM
|
www.mcmaster.com
|
HarpNinja
2038 posts
Dec 22, 2011
9:37 PM
|
I called Hohner this AM and they had already sent me a bunch of screws after seeing my post! They have them for sell for public if you call them direct.
Sweet!!!
Normally, I would start by calling them, but it was after hours when I posted.
----------
Mike
VHT Special 6 Mods
Quicksilver Custom Harmonicas - When it needs to come from the soul...
|
